It is important to keep
your wiring secure and supported off the frame. Below is how I like
to make my wiring standoff supports.
First cut a piece of soft rubber or
plastic tubing to the desired length. Insert a zip tie through the
center of the tube piece that you will use for your standoff.
The above photo shows the support tube
with the zip tie.
Next wrap the zip tie around your wire
bundle and then feed it back through the tube piece.
Above you can see the zip
tie is around the wire bundle and then wrapped around the support
(frame) member. The end is then inserted into the lock and pulled
tight enough to hold the wiring into the desired postition.
Above the wire bundle/cable is
firmly supported off of the frame and cushioned by the soft
plastic tubing.
Above is another shot of the wire
standoff in another area.